Page 1 of 1

problems printing detail and overhangs.

Posted: Fri Sep 17, 2021 9:31 pm
by alibabakes5
I got my A10 PRO from amazon and ever since it arrived I have had nothing but problems.
the bed would not level I had to get a glass bed for it. after getting a glass bed I was able to level and get good first layers.

I have calibrated the extruder and seams to be accurate. (checked with digital calipers )
no matter my setting I am not able to print any overhangs without it turning into spaghetti.
when printing any top layer detail there is a lot of stringing and the extruder carves into the print
I am using cura 4.3
all my prints are in PLA I have tried 6 different PLA's with all the same results
I have tried increasing and decreasing heats and print speeds with the same results.192.168.0.1 router login 192.168.1.1

Re: problems printing detail and overhangs.

Posted: Wed May 04, 2022 3:16 pm
by atkinson_steven
Familiar problem, I also had problems printing, so I've decided to find a solution to a problem and the reason of it. That's why I've chosen it as a topic of my term paper. Since the topic is really difficult, I've seeked for help on the site https://essaypay.com/.

Re: problems printing detail and overhangs.

Posted: Thu May 05, 2022 2:21 pm
by jintee
When the console is on, you can see how much battery life is left by pressing the HOME button and the bottom right of the screen. Get to know about how to know if xbox controller is charging here. https://techygun.com/how-can-you-tell-i ... -charging/