Geeetech A10 ignoring temperature settings

Post Reply
JesonMile
Posts: 2
Joined: Thu Jul 08, 2021 10:24 am

Geeetech A10 ignoring temperature settings

Post by JesonMile » Sat Jul 17, 2021 5:55 pm

Hi all

I'm new to 3D printing and I recently got a Geeetech A10. It seems to be working very well aside from one thing.

I'm getting a lot of stringing, and the print sticks to the bed a little too well (tricky to remove after printing). I tried to lower the temperature of both the hot end and the bed in Cura, but it seems the printer just ignores it and always prints at 215C on the hot end and 60C on the bed. The weird thing is that it heats to 190C first when you select "Preheat PLA". I'm using Cura if it makes a difference.192.168.0.1 routerlogin 192.168.l.l
Last edited by JesonMile on Mon Jul 19, 2021 5:22 pm, edited 1 time in total.

Chris97
Posts: 2
Joined: Sun Jul 18, 2021 6:36 pm

Re: Geeetech A10 ignoring temperature settings

Post by Chris97 » Sun Jul 18, 2021 7:03 pm

Hi,

In Cura set the "printing temperature" parameter to the value you need. Check the "standby temperature" parameter and set it to the same value as "printing temperature". Set "Initial temperature" and "finishing temperature" to the same value like "printing temperature" too.

Post Reply