A10T keeps stopping to re heat..

Moderator: vert

Post Reply
Posts: 1
Joined: Mon Mar 29, 2021 8:49 am

A10T keeps stopping to re heat..

Post by Ace66 » Sat May 15, 2021 8:23 pm

When printing a project, my A10T stops to reheat about every 5 minutes. Any help would be appreciated, sorry if this has been asked before.
It does not give an Error message. it just sets there and reheats then starts up again.
I am using CURA 4.91 and printing with color mixing of 3 colors.

User avatar
Posts: 380
Joined: Wed Nov 30, 2011 9:49 am

Re: A10T keeps stopping to re heat..

Post by Admin » Mon May 17, 2021 2:58 pm

Hello, if there is an error, what error is displayed on the screen?
However, the reason for the heating error is likely to be a poor connection. It is recommended that you tie the heating wire of the extruder with a cable tie, and check whether the thermistor and heating wire on the adapter board are loose.

Post Reply