Newbee printing problems

Post Reply
Chaoswill
Posts: 2
Joined: Tue Oct 13, 2020 10:46 pm

Newbee printing problems

Post by Chaoswill » Tue Oct 13, 2020 10:54 pm

Hi All,
I recently purchased an A10 and following assembly and brief intro, I managed to print out a couple of random trial objects.
However, the printer has developped a problem where the filament feed stepper motor 'judders' every 2-4 senonds resulting in a poor filament feed and no printing. Any ideas?

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Newbee printing problems

Post by Admin » Thu Oct 15, 2020 11:05 am

Hello, it may be that your extruder is loose. You can observe whether the screws are loose and you can adjust them with a screwdriver. It may also be that your printing speed is too fast. The printing speed can be adjusted. :D

Post Reply