Use of GT2560 in place of the V4 for A10 pro

[imag2020]

Hi,

The GT2560 V4 of my new A10 pro is not working (some capacitor was out of voltage and now it's not powring on)
I get a classical GT2560 but the connections of the LCD+SD is not the same.
In the two cards there is 20 pins but in the V4 all are in the same 'package' and in the card I buy there is two connections of 10 each, one for LCD and one for SD.
So I need the schema to connect LCD+SD of my A10 pro to the two connections of the 'old' GT2560

Hope my question is easy to understand, here is a photo for more details

Thank you in advance.

[William]

Hi，your question is whether this solution is feasible?

[imag2020]

Hi William,

My question is how to do that ? it must be possible, All I need is only to know each pin on both sides: on the ( GT2650 revision A+ card) and on the LCD/SD of my A10 pro printer.

Thank you.

[William]

Sorry. This is not feasible, the pins are different, and the firmware cannot be changed.

[imag2020]

Thank you for your response,

I already update firware of my G2560 revison A card,

Can you please help me to find pins description of the LCD of my A10 pro ? (there is 20 pins) any shema or notice ? I'll handel that

[William]

Correspond to this picture：

微信图片_20200609093432.png (8.01 KiB) Viewed 6258 times

[imag2020]

Thank you a lot William,

There's 20 pins in the LCD of my new 10pro, ther's only 10 on your schema.

[William]

Sorry for the mistake, this is

QQ图片20200610095826.png (42.8 KiB) Viewed 6220 times

[imag2020]

Thank you very match William,

So this is the pins of my LCD here (see pics)
I'll try and let you informed

Thank you again

[William]

Corresponds to this direction

微信图片_20200610152229.jpg (311.7 KiB) Viewed 6217 times