Page 1 of 1

Printing issues with my A10!

Posted: Mon Feb 17, 2020 8:29 am
by untersteiner
I just bought a Geeetech A10 and the prints come out like this, I'm looking for the solution days ago and I don't know what else to do. Try a lot of Cura configurations and none seems to work.
20200215_140335.jpg
20200215_140335.jpg (303.46 KiB) Viewed 734 times

Re: Printing issues with my A10!

Posted: Mon Feb 17, 2020 9:03 am
by William
Hi,You can download the configuration of the corresponding model of cura on the official website.

Re: Printing issues with my A10!

Posted: Fri Feb 21, 2020 2:30 am
by Volans
It looks like bad filament to me. If the nozzle pops and sputters in those bad areas, there is likely moisture in the filament.

Try a fresh spool or try to dry it out. I use Inland PLA a lot because I live near a Micro Center. I live in Denver, CO so moisture isn't a big concern to me.

If you don't think that is the problem, try this...

If the print seems uniformly thin, I would try to increase the flow rate. On Vert's Marlin 2.0.x builds, I find the setting at Configuration : Advanced Setting : Steps/mm : Esteps/mm :. My printer shows 98.0. If I wanted to increase the flow rate 5% I would use 103.0, for a 10% increase 108.0. I've pushed my Ender 3 to 115% flow rate on one of my filaments to get better prints.

Hope this helps!

Volans
- Jack of all Trades, Master of Integration!