Printing issues with my A10!

Post Reply
untersteiner
Posts: 1
Joined: Mon Feb 17, 2020 8:19 am

Printing issues with my A10!

Post by untersteiner » Mon Feb 17, 2020 8:29 am

I just bought a Geeetech A10 and the prints come out like this, I'm looking for the solution days ago and I don't know what else to do. Try a lot of Cura configurations and none seems to work.
20200215_140335.jpg
20200215_140335.jpg (303.46 KiB) Viewed 3269 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Printing issues with my A10!

Post by William » Mon Feb 17, 2020 9:03 am

Hi,You can download the configuration of the corresponding model of cura on the official website.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Volans
Posts: 3
Joined: Sat Feb 15, 2020 8:40 am

Re: Printing issues with my A10!

Post by Volans » Fri Feb 21, 2020 2:30 am

It looks like bad filament to me. If the nozzle pops and sputters in those bad areas, there is likely moisture in the filament.

Try a fresh spool or try to dry it out. I use Inland PLA a lot because I live near a Micro Center. I live in Denver, CO so moisture isn't a big concern to me.

If you don't think that is the problem, try this...

If the print seems uniformly thin, I would try to increase the flow rate. On Vert's Marlin 2.0.x builds, I find the setting at Configuration : Advanced Setting : Steps/mm : Esteps/mm :. My printer shows 98.0. If I wanted to increase the flow rate 5% I would use 103.0, for a 10% increase 108.0. I've pushed my Ender 3 to 115% flow rate on one of my filaments to get better prints.

Hope this helps!

Volans
- Jack of all Trades, Master of Integration!

Post Reply