-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Try a fresh spool or try to dry it out. I use Inland PLA a lot because I live near a Micro Center. I live in Denver, CO so moisture isn't a big concern to me.
If you don't think that is the problem, try this...
If the print seems uniformly thin, I would try to increase the flow rate. On Vert's Marlin 2.0.x builds, I find the setting at Configuration : Advanced Setting : Steps/mm : Esteps/mm :. My printer shows 98.0. If I wanted to increase the flow rate 5% I would use 103.0, for a 10% increase 108.0. I've pushed my Ender 3 to 115% flow rate on one of my filaments to get better prints.
Hope this helps!
- Jack of all Trades, Master of Integration!
Who is online
Users browsing this forum: No registered users and 31 guests