Leveling bed with glass platform

Post Reply
eddyuk
Posts: 48
Joined: Sun Oct 30, 2016 2:05 am

Leveling bed with glass platform

Post by eddyuk » Fri Jan 31, 2020 8:07 pm

Hi,

I have Geeetech A10T. I purchased a Superplate glass platform for it and installed it. Now, I can't find how to level the bed with it since it rises the surface in about 5mm.

Thanks
Top
Jarda3d
Posts: 189
Joined: Sat Jan 26, 2019 8:42 am

Re: Leveling bed with glass platform

Post by Jarda3d » Sat Feb 01, 2020 4:42 am

use screw dials on hotbed. Or push Z switch slightly higher, but not reccomend 5mm but 3-4mm only, adjust via bed then.
A10M Slic3r profile: here and fresh on github (lot of tips here)
A10 Slic3r profile: here
TIP: tight all screws and wheels (except right side of Z axis) and re-align frame while assembly. And silence it.
Top
eddyuk
Posts: 48
Joined: Sun Oct 30, 2016 2:05 am

Re: Leveling bed with glass platform

Post by eddyuk » Sat Feb 01, 2020 10:24 pm

Thanks. I tried the bed screws but it wasn't enough. Rising the Z sensor did the trick.
Top
Post Reply

Return to “Geeetech A10 Series”