A10M not ends print

Moderator: vert

Post Reply
Spqr59
Posts: 9
Joined: Wed Jan 01, 2020 5:27 pm

A10M not ends print

Post by Spqr59 » Tue Jan 21, 2020 7:20 pm

HI all,
i tried to print this owl from thingiverse: https://www.thingiverse.com/thing:18271
it's about 15 cm tall but when the printer were at approx 13 cm it stops extruding so it continues to print movements but with no filament.

what could be the problem in your opinion?

User avatar
William
Site Admin
Posts: 5136
Joined: Tue Jun 07, 2016 9:38 am

Re: A10M not ends print

Post by William » Wed Jan 22, 2020 9:38 am

:D Hi, You can see if your nozzle is clogged,
The nozzle temperature is around 200 and then manually push the consumables,
Check whether the nozzle is discharging.
If it is blocked, clean it up in time.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 7 guests