Klipper on A10T

Moderator: vert

Post Reply
AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Klipper on A10T

Post by AndreasThaler » Wed Nov 13, 2019 7:53 am

Hi there,
I am new to Geeetech printers. Up to now, I only used my Ender 3 (and SparkMaker). I love using Klipper on my Ender 3 and want to use it now with my new A10T. But... pins for the extruders? Sensor type? Sensor pin? Anyone experience with that?

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Mon Nov 25, 2019 8:05 am

Ok,
I see the .cfg for the A10M with:
step_pin: ar46
dir_pin: ar44
enable_pin: !ar12
for extruder 0

step_pin: ar49
dir_pin: ar47
enable_pin: !ar48
for extruder 1

BUT
I can´t find any documentation about the pins for extruder 2.
Help please!

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Tue Nov 26, 2019 5:59 am

step 43
Dir 45
EN 41

A guy in the Geeetech 3D Printer User Club just answered.
Bruce Greenleaf

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Tue Nov 26, 2019 8:14 am

He measured and installed Marlin 2.0.

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Fri Dec 06, 2019 6:11 am

I am afraid, there is no working bootloader on my A10T :(

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Tue Dec 10, 2019 11:41 pm

There IS a working bootloader on the A10T. You have to press the "reset"-button while flashing! Crazy!
But now, I installed Klipper. The pins for E2 ARE right!

AndreasThaler
Posts: 7
Joined: Wed Nov 13, 2019 7:49 am

Re: Klipper on A10T

Post by AndreasThaler » Wed Dec 11, 2019 12:22 am

Here the working printer.cfg
printer.zip
(2.02 KiB) Downloaded 307 times

Post Reply