A10M Stringing / Oozing (Same Settings - Different Results)

Tommies
Posts: 13
Joined: Tue Jul 02, 2019 3:37 am

Re: A10M Stringing / Oozing (Same Settings - Different Results)

Post by Tommies » Fri Aug 30, 2019 4:15 am

Hello,
for my a10 i use
130 mm/s travel speed (but i'm going to try higer speed)
6000 mm/s retractation speed

toxic
Posts: 9
Joined: Wed Oct 30, 2019 6:45 am

Re: A10M Stringing / Oozing (Same Settings - Different Results)

Post by toxic » Tue Feb 18, 2020 4:22 am

I use PTEG and did a lot of calibrations but still have oozing. Did removing little disks from the hotend will solve that problem?
IMG_20200215_191254.jpg
IMG_20200215_191254.jpg (218.12 KiB) Viewed 4174 times
IMG_20200217_212904.jpg
IMG_20200217_212904.jpg (441.61 KiB) Viewed 4174 times

pakbehl
Posts: 1
Joined: Mon Jul 13, 2020 6:35 pm

Re: A10M Stringing / Oozing (Same Settings - Different Results)

Post by pakbehl » Mon Jul 13, 2020 6:45 pm

This thread was quite helpful for me, I thought I'd try to contribute...
I'm curious to know if you found better solutions since the last post?
My suggestion at this point, given what I've seen so far, is that z-hopping should be the final solution to that pesky end-of-layer string if you can't get it fixed with retraction, temperature, speed, or altering the extruder path with combing, seam-hiding, etc.

Post Reply