a couple of questions

[ebam2014]

Hi all

been a while since I posted as went over to the dark side and bought an SLA printer...

Still been using my A10 just not as much... But now Xmas is getting nearer so the A10 will be being used more...

So I thought I check to see whats the latest offical firmware for the A10 and whats the best firmware over all?

Secondly the 3d touch module does it actually level bed or is it as I suspect it just warns you its not level??? Thinking of getting one as an upgrade to the A10.

And finally what are the best/recommended mods for the A10?


Regards Ebam

[William]

Hi, For A10 firmware download you can go to the official website to download: https://www.geeetech.com/download.html?download_id=30
HEX firmware,

then through CURA slicing software settings - manger printer - printer to update the firmware.

About 3d touch you can pass this: http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
Learn more in detail.

I hope this can help you.

[ebam2014]

Hi, For A10 firmware download you can go to the official website to download: https://www.geeetech.com/download.html?download_id=30
HEX firmware,

then through CURA slicing software settings - manger printer - printer to update the firmware.

About 3d touch you can pass this: http://www.geeetech.com/wiki/index.php/ ... ing_Sensor
Learn more in detail.

I hope this can help you.

thats a bit odd.. My a10 was bought this time last year and firmware is newer than one on geeetch site!!!!!!!!!!!!!!!!!! Geeetch is V1.0 mine is v1.0.04

[William]

you can refer to this；

XOL2KGQCBMSQ)KJZ$R6C`LY.png (53.34 KiB) Viewed 9265 times

[ebam2014]

you can refer to this；XOL2KGQCBMSQ)KJZ$R6C`LY.png

cool thank you for pointing that out...


is there a firmware update for 3dwifi module?

[William]

Hi, You can choose the firmware you need through the official website.
https://www.geeetech.com/download.html?download_id=30

[ebam2014]

Cura wil not work on my machine so I use repeiter is there another way update firmware on printer? without a huge download?

[William]

Hi, Then you can download accordingly through this:http://www.geeetech.com/forum/viewtopic ... 20&t=17046
Update the firmware with Arduino 1.8.5,
Specific operations can refer to this:http://www.geeetech.com/forum/viewtopic ... 20&t=17181

[ebam2014]

managed to do it... but now I have an issue... x,y,z are now flashing ? symbol!!!!


is there something else I am supposed to do?

[William]

Hi, Can you describe the specific operation or provide a specific video?
So that we can solve the problem better,
Did you use Arduino to update the firmware?