Under A10 Faq i found this.
5.jpg (221.16 KiB) Viewed 50048 times
1.4 Check the voltage of the motor driver and the motor connector.
Measure the voltage of the driver board, normally the value should be 0.8V-1.2V, you can put the red probe of multimeter on the potentiometer,
http://www.geeetech.com/forum/viewtopic ... 17&t=17038
I'm assuming you've got the stock A598 drivers which are the noise ones. For those anywhere between 0.8 and 1.2 is good.
If you're experiencing issues at 0.8 try increasing to 1.2
If you have TMC2208 drivers (The quiet ones) then 0.8 is the correct value.
Who is online
Users browsing this forum: No registered users and 3 guests