zonalimitatore wrote: ↑Tue Aug 28, 2018 10:44 pm
Perfect.Tonight i try to flash
Thanks
Into the menu you found the new setting "manual leveling"
To use them klick the wheel down and start the leveling. The A10 now drives 9 points on the heating bed, starting with point 1.
Put a piece of paper under the nozzle and turn the wheel up and down until the distance fits.
Push the wheel down and the A10 move to position 2.This is done with all 9 points from the heatbed.
After point 9 you here a "Sound" thats say "configuration saved into the EEPROM"
Into the leveling menu you could set "Leveling correction" to "Yes"
The printer use your own points from the heatbed to correct the z-axis now!
You didn't redo level of every print. If prints are bad you could level again.
Bevor leveling the heatbed look under your nozzle, because to level the heatbed there must not be any filament under the nozzle!!!
Try it.
![Mr. Green :mrgreen:](./images/smilies/icon_mrgreen.gif)
The results with manual 9 point leveling and 0.1 layer high are very, very good!!!