Outer wall /. inner wall connection

Post Reply
Chub
Posts: 51
Joined: Sun Jan 13, 2019 2:35 am

Outer wall /. inner wall connection

Post by Chub » Thu May 14, 2020 10:02 am

Using Cura 4.6.1 on A10M. Why don't I get good connection between the inner and outer wall? I tried increasing over lap and no change
Attachments
15894216990317010083877412999227.jpg
15894216990317010083877412999227.jpg (247.9 KiB) Viewed 3733 times
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Outer wall /. inner wall connection

Post by William » Thu May 14, 2020 12:04 pm

Hi,have you set the mixing ratio? Maybe one of the extruders has no material.
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
Chub
Posts: 51
Joined: Sun Jan 13, 2019 2:35 am

Re: Outer wall /. inner wall connection

Post by Chub » Thu May 14, 2020 8:22 pm

I am running 100% of extruder 1. No mix.
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Outer wall /. inner wall connection

Post by William » Fri May 15, 2020 2:33 pm

Hi,my friend.
I suggest you use repeater - host.
There are configuration files on the official website.
You don't have to worry about slice settings.
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
Post Reply

Return to “Geeetech A10 Series”