New Mecreator2 PrusaSlicer issue

Post Reply
DroneOn
Posts: 2
Joined: Mon Nov 25, 2019 3:35 am

New Mecreator2 PrusaSlicer issue

Post by DroneOn » Mon Nov 25, 2019 4:13 am

Hi,
Just fired up my new Mecreator2, if I auto home via the LCD it homes to X175 Y165 and Z0. I set bed size to 160x160 in PrusaSlicer, run a print and the carriage slams into the left (X0) side. I autohomed again and checked the X travel, display reads X175 when homed but will only travel to X20 before slamming into the left rail. I adjusted the bed size to 155x160 and it still slams into the left side at the beginning of the print.
So it seems I do not have the advertised 160x160 print volume. Any assistance would be appreciated thanks.

DroneOn
Posts: 2
Joined: Mon Nov 25, 2019 3:35 am

Re: New Mecreator2 PrusaSlicer issue

Post by DroneOn » Mon Nov 25, 2019 7:44 am

Thanks for the response. I guess I will dig into the code and see what I can do to remedy the situation.

Post Reply