Geeetech Prusa i3 Pro W won't lay down first layer, help.

[agustusin]

So I finished my Pro W build. I leveled the bed and tried a test print. It seems as though, even though autohome puts the nozzle a piece of paper away from the bed, that when it starts to print the nozzle is too far away.

I've included a Drive link to the gcode I was using and a video of what it was doing. (This video has a lot of "squeak" from the z-rail but has since been fixed with the same issue.)

I've tried different firmwares with the same results.

Any help would be appreciated.