Hi guys,
At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.
Flashed the firmware and set
https://nox.tips/ https://xender.vip/
#DEFINE INVERT_E0_DIR true
#DEFINE INVERT_E0_DIR false
I also set all extruders to true/false
Swapped the plug around
Tried different printing software
Does anyone else have any other ideas?
All of those methods above result in my extruder pushing the filament out.
Geeetech i3 Pro W - Extruder going wrong way
Geeetech i3 Pro W - Extruder going wrong way
Last edited by bikasehel on Wed Feb 02, 2022 5:53 pm, edited 1 time in total.
Re: Geeetech i3 Pro W - Extruder going wrong way
Drain Tile Installation Can Be Put in Place on the Exterior of the Home’s Foundation, or on the Interior of the Foundation Underneath the Slab of Flooring