Hej,
I just installed the 3D Touch on My I3 Pro W with selve printed mount from instruction, installed the Firmware from this Forum for this and added Code G29 in Cura for My prints. I can see that the Printer is doing the autolevelling, but the result in Z axis is just a few Millimeter too high, therefore the nozzle prints 'in the air' above the bed. What do I Need to adjust here? There is no way to put the 3D Touch sensor higher with this mount.
Thank you in advance for some advice.
Z axis too high with 3D Touch
-
- Posts: 2
- Joined: Sun Apr 19, 2020 8:35 pm
Re: Z axis too high with 3D Touch
Hi,
Maybe your firmware needs to be updated? You can download it on the official website.
Maybe your firmware needs to be updated? You can download it on the official website.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!