Only 1 Z Axis Motor Running
Posted: Fri Apr 10, 2020 10:40 am
Hi
This is my first build, but I'm not entirely clueless. Everything is hooked up correctly from what I can tell, however there seems to be something wrong at the 2560 end. On manual control all motors work as expected except one z axis motor. If I change the cable, the other motor works. If I completely change all cables, same issue, so it's not a cable problem, and it's not a motor problem. It seems to be lying in the output from the 2560 board.
Checking here to see if I'm missing something. I did adjust the potentiometer but that didn't seem to make a difference.
Would appreciate any guidance as to what I could check.
Thanks
Paul
This is my first build, but I'm not entirely clueless. Everything is hooked up correctly from what I can tell, however there seems to be something wrong at the 2560 end. On manual control all motors work as expected except one z axis motor. If I change the cable, the other motor works. If I completely change all cables, same issue, so it's not a cable problem, and it's not a motor problem. It seems to be lying in the output from the 2560 board.
Checking here to see if I'm missing something. I did adjust the potentiometer but that didn't seem to make a difference.
Would appreciate any guidance as to what I could check.
Thanks
Paul