Unrealiable Filament Extrusion

Post Reply
Cfluxe
Posts: 1
Joined: Sat Nov 16, 2019 4:31 am

Unrealiable Filament Extrusion

Post by Cfluxe » Sat Nov 16, 2019 4:34 am

Hi everyone,

Currently having an issue with the printer not always extruding enough filament or just not putting any half everyone now and again through a print (I attached some images below to have a look) I pulled out the filament and it was really squeezed at some points (again image attached below)
I have tried upping the temperature and feed rate but not sure where to go from this.
Any help is much appreciated

Cflux
Attachments
IMG_20191115_202932.jpg
IMG_20191115_202932.jpg (175.1 KiB) Viewed 2875 times
IMG_20191115_202930.jpg
IMG_20191115_202930.jpg (159.31 KiB) Viewed 2875 times
IMG_20191115_202938.jpg
IMG_20191115_202938.jpg (195.15 KiB) Viewed 2875 times
IMG_20191115_202957.jpg
IMG_20191115_202957.jpg (336.68 KiB) Viewed 2875 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Unrealiable Filament Extrusion

Post by William » Mon Nov 18, 2019 9:22 am

:D Hi,Cfluxe.
You can check if your supplies are fully inserted.
Then check if the spring of the feeder is too loose, you can add cardboard at the spring to increase the spring force;
Then measure the drive plate of the extruder, the normal range: 0.8-1.2V
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply