Geeetech

Hello all, i hope you have a nice sunday.
So i have buy a geetech pro w and i have finish all the installation and uploadé the last firmware.

I have test to print a calibration cube and i have imperfection.

Can you help me to understand the problems?
Sorry for my bad englich i come from france

I have tested with other paramètres and that no work better

Hi, You may need to check the following points:
1. Check whether the bearing or the pulley is issued (the card can be lubricated for lubrication);
2. Check if there is looseness and tighten it properly;
3. Whether the printing speed is too fast, can be adjusted appropriately, the reference range: 30-60mm/s.

I hope this can help you.