I need help for calibration

Post Reply
David67000
Posts: 2
Joined: Sun Sep 08, 2019 7:56 pm

I need help for calibration

Post by David67000 » Sun Sep 08, 2019 8:10 pm

Hello all, i hope you have a nice sunday.
So i have buy a geetech pro w and i have finish all the installation and uploadé the last firmware.

I have test to print a calibration cube and i have imperfection.

Can you help me to understand the problems?
Sorry for my bad englich i come from france :roll:
Attachments
20190908_140842.jpg
20190908_140842.jpg (619.08 KiB) Viewed 220 times
20190908_140808.jpg
20190908_140808.jpg (848.85 KiB) Viewed 220 times
20190908_140717.jpg
20190908_140717.jpg (636.97 KiB) Viewed 220 times

David67000
Posts: 2
Joined: Sun Sep 08, 2019 7:56 pm

Re: I need help for calibration

Post by David67000 » Mon Sep 09, 2019 12:51 am

I have tested with other paramètres and that no work better :lol:
Attachments
20190908_185041.jpg
20190908_185041.jpg (882.58 KiB) Viewed 208 times
20190908_185054.jpg
20190908_185054.jpg (686.84 KiB) Viewed 208 times
20190908_185108.jpg
20190908_185108.jpg (458.58 KiB) Viewed 208 times

User avatar
William
Site Admin
Posts: 4367
Joined: Tue Jun 07, 2016 9:38 am

Re: I need help for calibration

Post by William » Mon Sep 09, 2019 9:57 am

Hi, You may need to check the following points:
1. Check whether the bearing or the pulley is issued (the card can be lubricated for lubrication);
2. Check if there is looseness and tighten it properly;
3. Whether the printing speed is too fast, can be adjusted appropriately, the reference range: 30-60mm/s.

I hope this can help you.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests