Z axis won't go up
Posted: Sat Jun 08, 2019 9:29 am
So I had quite a bit of problems with the printer, but I solved most of them except this one I can't figure out. I start a test print and everything looked fine until the extruder wasn't able to lift up any higher and remained at the same level.
I can get my z axis to home just fine, there is no issue with both motors lowering the axis. However the z motor on the left side doesn't do anything when I try to move it upward. The right z motor turns on and lifts the axis a little bit, but then stops and starts to grind because the other motor isn't doing anything.
Any ideas?
I can get my z axis to home just fine, there is no issue with both motors lowering the axis. However the z motor on the left side doesn't do anything when I try to move it upward. The right z motor turns on and lifts the axis a little bit, but then stops and starts to grind because the other motor isn't doing anything.
Any ideas?