Page 1 of 1

Updating Marlin to 1.1.x Version

Posted: Fri Mar 29, 2019 11:57 pm
by lucasdimi
Hi, i want to make sure how to update to Marlin 1.1.x. is there more configuration needed after installing via Arduino IDE the Marlin code downloaded?
If so, what configurations are recommended or need to set to this printer.
I'm actually having issues with OctoPrint that sends M117 codes with '*' characters and seems that my Marlin version does not support that, and it's have been fixed in the latest 1.1.x


Re: Updating Marlin to 1.1.x Version

Posted: Wed Apr 03, 2019 2:57 pm
by William
Vert made a super program of Marlin2.x.You can refer to his post then try to upload it to your printer and test.