Page 1 of 1

Extruder going in the wrong direction

Posted: Tue Mar 19, 2019 5:04 am
by awestom
Hi guys,



At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.

Code: Select all

 - Flashed the firmware and set
 - - #DEFINE INVERT_E0_DIR true
 - - #DEFINE INVERT_E0_DIR false
 - - - I also set all extruders to true/false
 - Swapped the plug around
 - Tried different printing software


Does anyone else have any other ideas?

All of those methods above result in my extruder pushing the filament out.

Re: Extruder going in the wrong direction

Posted: Wed Mar 20, 2019 2:28 pm
by William
You need to refer to the FAQ for the I3 type printer.
It will show you how to change the dir of the motor.