cant seem to calibrate my axis on my geeetech pro w

Post Reply
hi-jam
Posts: 1
Joined: Tue Jun 12, 2018 1:22 am

cant seem to calibrate my axis on my geeetech pro w

Post by hi-jam » Tue Jun 12, 2018 1:29 am

Just finished the build of my geeetech I3 pro W and z axis wont calibrate, plus i was checking the wiring on the board and all looks good but i did hit the reset on the board and now my desplay wont work unless it is plugged into my laptop. Any idea or help would be great.

Gingko
Site Admin
Posts: 230
Joined: Tue Apr 24, 2018 10:43 am

Re: cant seem to calibrate my axis on my geeetech pro w

Post by Gingko » Tue Jun 12, 2018 2:26 pm

Reburn the firmware to have a try.

Gingko
Site Admin
Posts: 230
Joined: Tue Apr 24, 2018 10:43 am

Re: cant seem to calibrate my axis on my geeetech pro w

Post by Gingko » Tue Jun 12, 2018 5:41 pm

For Z-axis issue, you can check this post first:
http://geeetech.com/forum/viewtopic.php?f=82&t=60931

donny
Posts: 6
Joined: Sat Jun 23, 2018 2:27 am
Location: virginia

Re: cant seem to calibrate my axis on my geeetech pro w

Post by donny » Wed Jul 11, 2018 7:26 am

calibrate it like its binding on you or the two motors are not level? use bearing grease on all the rods

Post Reply