Sarting with i3 pro W

Post Reply
Macsnow
Posts: 0
Joined: Fri Apr 20, 2018 1:38 am

Sarting with i3 pro W

Post by Macsnow » Fri Apr 20, 2018 5:48 am

Hi there.

I'm a new in this world, and recent I finished building my pro W, and take some notes in the way, for a build properly. so i share for everyone become with that printer.

Geeetech prusa I3 W (Board gt2560 + 4A4988)

# Building instrucctions. (video List)

https://www.youtube.com/watch?v=gMbsUa6 ... KfZE41VtgG

# Wiring tutorial: https://www.youtube.com/watch?v=sqQI_-4UNp0

#Leveling bed https://www.youtube.com/watch?v=K-3YuzdeO2M (manual)

Board gt2560 + 4A4988
Driver ch340 viewtopic.php?f=21&t=60612

perfil of the printer in cura prusa i3 mk2. (work for me)

# Tutorial how to upload firmware http://www.geeetech.com/wiki/index.php/ ... le_Burning
# Firmware list viewtopic.php?f=20&t=17046
# Marlin 1.1.8 viewtopic.php?f=82&t=61011 (for arduino 1.8.5)

# Basic of marlin. https://www.youtube.com/watch?v=eVOLPIq ... vvfv9X_tN6

(check this list of videos, maybe helps for someone. https://www.youtube.com/playlist?list=P ... vvfv9X_tN6)

If you try upload a firmware check with version of arduino you need. (somecase is a old version)

Check always the firmewares before uploads.

so with that you should start attempt to print.

dang
Posts: 3
Joined: Sun Mar 07, 2021 1:15 am

Re: Sarting with i3 pro W

Post by dang » Sun Mar 07, 2021 2:59 am

Hi ,

Thanks for that post. But I'm still lost with all the FW list... I have a Pro I3 W with board GT2560+4A4988 and there is fw relating to A10, A10M, A20, A20M how to know which one is the right one?

Thanks and much appreciate

Dang

User avatar
DaveJ61
Posts: 3
Joined: Tue Apr 03, 2018 6:50 pm

Re: Sarting with i3 pro W

Post by DaveJ61 » Fri Feb 18, 2022 1:48 pm

Hi,
I know this thread is quite old and I hope you've found a solution by now. If not, you need to scroll further down, perhaps two-thirds down. It is there because I downloaded it yesterday.
Here is the link to the GT2560a+ with 3dtouch autoleveler - https://www.geeetech.com/forum/download ... hp?id=4260
If you don't need the auto bed leveling, just comment out the line for it in configuration.h of the firmware.
Kind regards

David

Post Reply