Filament out detector on i3 Pro C

Post Reply
Softfoot
Posts: 26
Joined: Tue Oct 01, 2019 6:42 pm

Filament out detector on i3 Pro C

Post by Softfoot » Mon Feb 03, 2020 6:14 am

I am running the firmware that was on this board for 1.1.8 on this printer and all works well.

However, I want to fit a filament out detector but I cannot get it to work - I believe I have made the changes required and it is plugged into "X_MAX" socket.

What worries me is that the M119 command reports the X/Y/Z_MIN pin states but not the X_MAX or filament out.

Has anyone installed one of these on this machine ?? and if so what rev of the firmware was needed.
Perhaps they might share thire config file ?

I am a bit reluctant to move to marlin 2.0.x at this stage.

Any help welcome
Dave

User avatar
William
Site Admin
Posts: 5983
Joined: Tue Jun 07, 2016 9:38 am

Re: Filament out detector on i3 Pro C

Post by William » Mon Feb 03, 2020 9:50 am

Hi,This setting is not recommended.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests