Only one extruder visible from LCD menu

Post Reply
Posts: 1
Joined: Fri Jan 24, 2020 5:07 pm

Only one extruder visible from LCD menu

Post by luca.aless.2011 » Fri Jan 24, 2020 5:56 pm

I just assembled the I3 Pro C
Everything works fine except for this:
In the LCD menu Prepare/move Axis I can visualize only one EXTRUDER and not EXTRUDER 1 and EXTRUDER 2
When I try to move the Extruder from the menu, both extruders works at the same time
I'm controling both extruders together.
It seems as if the firmware is set for one extruder only
From the menu I can see and control the temperature of two nozzles, so it seems the firmware loaded is the correct one for two nozzles but probably for only one extruder
Extruder 2 rotates opposite, so I cannot load the filament
How can I get the printer to recognize two extruders and to control them separately?
Had anyone had the same issue?

User avatar
Site Admin
Posts: 5983
Joined: Tue Jun 07, 2016 9:38 am

Re: Only one extruder visible from LCD menu

Post by William » Thu Jan 30, 2020 6:41 pm

Hi,The two extruders are on the same horizontal line, and you can observe where the extruders are located.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests