I3 ProC Dual Extruder does not start up
Posted: Thu Sep 19, 2019 5:26 am
Hey,
I bought a i3 pro c dual extruder a few months ago and finally had the time to build it and start setting it up .
I can connect the printer via usb to my computer and was able to both connect it to repetier host and to install the firmware ( marlin 1.1.8), however when i connect it, the printer doesn't seem to start anything. I can not move the extruder in any direction ( the stepper motors are not turning on) and i can't heat the bed or extruder. It is plugged in and i am pretty sure i assembled everything correctly. There is a green led on on the board and the lcd screen turns on as well. When i try to heat one of the extruder it shows up on the lcd screen, that the extruder is starting to heat up, but before actually heatng up it says that it failed ( Error: Heating failed, system stopped! Heater_ID: 0
I am not quite sure what i am doing wrong.
If anyone could help me it would be greatly appreciated.
Carl
I bought a i3 pro c dual extruder a few months ago and finally had the time to build it and start setting it up .
I can connect the printer via usb to my computer and was able to both connect it to repetier host and to install the firmware ( marlin 1.1.8), however when i connect it, the printer doesn't seem to start anything. I can not move the extruder in any direction ( the stepper motors are not turning on) and i can't heat the bed or extruder. It is plugged in and i am pretty sure i assembled everything correctly. There is a green led on on the board and the lcd screen turns on as well. When i try to heat one of the extruder it shows up on the lcd screen, that the extruder is starting to heat up, but before actually heatng up it says that it failed ( Error: Heating failed, system stopped! Heater_ID: 0
I am not quite sure what i am doing wrong.
If anyone could help me it would be greatly appreciated.
Carl