Page 1 of 1

Z Axis Steps problem...

Posted: Thu Jul 04, 2019 9:40 am
by Mr.Hotwire
I'm going threw a MESS of a build, I updated to Marlin 1.1.8 and I had a steps problem. I compared it to the 1.0.2 firmware that was on it and made some edits so that things matched.

They don't..

My print now looks like this:
MVIMG_20190703_183602.jpg
MVIMG_20190703_183602.jpg (186.68 KiB) Viewed 2314 times
The board is an A+ board so the 1.1.8 firmware should be good for it.

What am I missing?

Re: Z Axis Steps problem...

Posted: Thu Jul 04, 2019 10:33 am
by William
Hi, from the picture, you may need to adjust the distance between the hotbed and the nozzle.

Re: Z Axis Steps problem...

Posted: Tue Jul 09, 2019 3:07 am
by Mr.Hotwire
Turns out the steps was the problem. rather then the 2560 it should have been... it was only 50...