Geeetech

Posted: **Thu Jul 04, 2019 9:40 am**

I'm going threw a MESS of a build, I updated to Marlin 1.1.8 and I had a steps problem. I compared it to the 1.0.2 firmware that was on it and made some edits so that things matched.

They don't..

My print now looks like this:

: MVIMG_20190703_183602.jpg (186.68 KiB) Viewed 5102 times

The board is an A+ board so the 1.1.8 firmware should be good for it.

What am I missing?

Posted: **Thu Jul 04, 2019 10:33 am**

Hi, from the picture, you may need to adjust the distance between the hotbed and the nozzle.

Posted: **Tue Jul 09, 2019 3:07 am**

Turns out the steps was the problem. rather then the 2560 it should have been... it was only 50...

Geeetech

Z Axis Steps problem...

Z Axis Steps problem...

Re: Z Axis Steps problem...

Re: Z Axis Steps problem...