Z Axis Steps problem...

Post Reply
Mr.Hotwire
Posts: 21
Joined: Mon Jun 24, 2019 9:16 am

Z Axis Steps problem...

Post by Mr.Hotwire » Thu Jul 04, 2019 9:40 am

I'm going threw a MESS of a build, I updated to Marlin 1.1.8 and I had a steps problem. I compared it to the 1.0.2 firmware that was on it and made some edits so that things matched.

They don't..

My print now looks like this:
MVIMG_20190703_183602.jpg
MVIMG_20190703_183602.jpg (186.68 KiB) Viewed 2221 times
The board is an A+ board so the 1.1.8 firmware should be good for it.

What am I missing?

User avatar
William
Site Admin
Posts: 6322
Joined: Tue Jun 07, 2016 9:38 am

Re: Z Axis Steps problem...

Post by William » Thu Jul 04, 2019 10:33 am

Hi, from the picture, you may need to adjust the distance between the hotbed and the nozzle.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Mr.Hotwire
Posts: 21
Joined: Mon Jun 24, 2019 9:16 am

Re: Z Axis Steps problem...

Post by Mr.Hotwire » Tue Jul 09, 2019 3:07 am

Turns out the steps was the problem. rather then the 2560 it should have been... it was only 50...

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests