Page 1 of 1
Controlling both extruders through control panel
Posted: Mon Jan 28, 2019 3:01 pm
by adrewbus
Why is there only one extruder under the move axis menu? Should there be two? I just setup the printer and am having trouble feeding filament into the second extruder. Thanks.
Re: Controlling both extruders through control panel
Posted: Mon Jan 28, 2019 9:47 pm
by William
I've checked the firmware of the PROC.
The menu of the PROC LCD is not correct. Maybe you can feedback it to the
technical@geeetech.com
Re: Controlling both extruders through control panel
Posted: Tue Jan 29, 2019 5:46 am
by Tparent
Hello,
Which Marlin FW Version ?
Thierry
Re: Controlling both extruders through control panel
Posted: Tue Jan 29, 2019 9:39 am
by adrewbus
It currently has Version 1.0.04 as updated through the easy print software.
I also loaded the firmware on the firmware page,
http://www.geeetech.com/forum/viewtopic ... 20&t=17046, using arduino. It loads as version 1.0.03.