Re: 3D touch
Posted: Wed Aug 21, 2019 2:06 pm
Hi William
I am using the firmware you posted here
http://www.geeetech.com/forum/viewtopic ... 439#p97644
I installed it using Arduino 1.8.8
The problem is the 3D Touch does not respond to g code commands. It self tests on power up but is not responding to M280 P0 S10 when sent thro Repetier Host.
I also manually modified the firmware to add the 3D Touch as instructions on the wiki page
The problem is the pins.h instructions the lines to be altered are not there they are on the ultimaker pins file is this correct ?
Any help would be appreciated.
I am using the firmware you posted here
http://www.geeetech.com/forum/viewtopic ... 439#p97644
I installed it using Arduino 1.8.8
The problem is the 3D Touch does not respond to g code commands. It self tests on power up but is not responding to M280 P0 S10 when sent thro Repetier Host.
I also manually modified the firmware to add the 3D Touch as instructions on the wiki page
The problem is the pins.h instructions the lines to be altered are not there they are on the ultimaker pins file is this correct ?
Any help would be appreciated.