I have the aluminum i3. When I set my value for the zstep/mm, the controller won't keep the value I've set. If I back out of programming, or if I shut off the unit, it just defaults at 2560...
Also, when the unit is on for 4 or 5 minutes, my screen goes garbled. I have to unplug the machine to get it to reset....
I've updated the firmware, but nothing...
Aluminum Prusa i3 Memory Issues
Aluminum Prusa i3 Memory Issues
- Attachments
-
- 2018-12-09 04.04.29.jpg (211.68 KiB) Viewed 13821 times
Re: Aluminum Prusa i3 Memory Issues
Hello.
Can you show a photo of how you laid the cables?
Also the cables to the display module.
Can you show a photo of how you laid the cables?
Also the cables to the display module.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: Aluminum Prusa i3 Memory Issues
1.Try to restart the printer
2.Try to check the wires short circuit or not
2.Try to check the wires short circuit or not
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Aluminum Prusa i3 Memory Issues
I had a garbled screen when the power was off but the USB cable was plugged into the socket and a laptop.
Re: Aluminum Prusa i3 Memory Issues
The board GT2560A can use the power of the USB.You can remove it then restart it
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!