USB device not recognized
Posted: Sun Aug 12, 2018 6:33 pm
Already followed the instructions:
[*]Quick Start Manual (install CDM v2.12.00 WHQL Certified.exe)
[*]viewtopic.php?f=21&t=60612&p=81974#p81974
Procedure installed:
1. installed CDM v2.12.00 WHQL Certified.exe
2. Restarted PC
3. Connected M201 USB to Windows10 64 PC
USB Device NOT recognized
- The last usb device you connected to this computer malfunctioned, and windows does not recognize it.
Tried remedy to no success:
1. Device Manager
2. Update Driver
3. Browse my computer for driver software
4. let me pick from list of available drivers on my computer
5. show compatible hardware (uncheck)
6. found Manufacture FTDI
7. Select each model one by one.......
So far nothing, which model should I select for windows10?
FT4222 Interface A version: 2.12.0.0 [8/26/2014]
FT4222 Interface A version: 2.12.6.0 [7/10/2015]
................................ etc
There are too many to try one by one. Which works with Geeetech Prusa I3 M201 Dual extruder Mixcolor open
[*]Quick Start Manual (install CDM v2.12.00 WHQL Certified.exe)
[*]viewtopic.php?f=21&t=60612&p=81974#p81974
Procedure installed:
1. installed CDM v2.12.00 WHQL Certified.exe
2. Restarted PC
3. Connected M201 USB to Windows10 64 PC
USB Device NOT recognized
- The last usb device you connected to this computer malfunctioned, and windows does not recognize it.
Tried remedy to no success:
1. Device Manager
2. Update Driver
3. Browse my computer for driver software
4. let me pick from list of available drivers on my computer
5. show compatible hardware (uncheck)
6. found Manufacture FTDI
7. Select each model one by one.......
So far nothing, which model should I select for windows10?
FT4222 Interface A version: 2.12.0.0 [8/26/2014]
FT4222 Interface A version: 2.12.6.0 [7/10/2015]
................................ etc
There are too many to try one by one. Which works with Geeetech Prusa I3 M201 Dual extruder Mixcolor open