Each time the printer is turned on, this toddler operates at full power. It makes a horrible noise. No matter if it is needed or not.
That's why I do not like him very much. But it's not his fault ;-D
I was so mad at him that I invented a quick effective solution.
I dealt with him using one additional connection.
yes, no joke. By adding one wire I got individual control for this small fan. ;-D
Having knowledge from previous kaktus' guides it was not difficult to do.
I unplugged the cable located near the head cart.
An additional cable connected the fan to the EXT2 socket, pin 6
Of course, we're talking about a fan cable with a GND signal.
Using this way I got full control of the fan control from the program used by me.
The solution is fabulously simple and effective. It is therefore recommendable.
That's why I present them.
Video with the presentation: https://www.youtube.com/watch?v=PPMQvdSp644
it's worth listening carefully ;-D
- przepis_na_wnetylator.jpg (310.73 KiB) Viewed 10353 times
The next description was created in the topic about fans of our printer.
Everything indicates that this one will be the last one, directly related to fans.
A link to the description.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Who is online
Users browsing this forum: No registered users and 8 guests