Post
by _kaktus_ » Mon Jun 24, 2019 11:31 pm
_kaktus_ wrote: ↑Tue Jun 18, 2019 12:39 pm
...
[*]Measure again, compare it with the line you took earlier. If it's in a good position, you don't have to do anything. Otherwise, in the printer configuration change the number of steps to 1mm for the extruder motor.
...
I can see now...
It's my mistake, I apologize for the confusion.
I had to write it very quickly and I didn't notice my mistake, I corrected it.
this movie will make it easier for us to communicate. The printer is different, but the principle is the same.
https://www.youtube.com/watch?v=Kgy8hVKxtVs
If you don't like this movie, you'll successfully find another one.
Bs2000 wrote: ↑Mon Jun 24, 2019 9:09 pm
...
I do understand the estep however you said you changed to 101 but your screen shows 9* something.
...
There's an explanation over the photo, I wrote there that it was a default setting.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
