Z axis problem

oliverharry12
Posts: 1
Joined: Wed Aug 03, 2022 1:09 am

Re: Z axis problem

Post by oliverharry12 » Wed Aug 03, 2022 1:11 am

I look to the steper motors and they turn after layer change but i think they turn to little.

I changed the step motor controllers between z and x axis without success.

I used cura for the first time and the fine with 0.1mm also i try some gcodes but i dont know now which one. Before that everything was ok

I tried also a firmware reflash without success.

I think it is no mechanical problem only a software variable one.

Please help me what i can try and how to reset everything to factory defaults.

kalpananetha112
Posts: 1
Joined: Mon Aug 15, 2022 10:48 pm

Re: Z axis problem

Post by kalpananetha112 » Mon Aug 15, 2022 10:51 pm


Post Reply