G2 pro - warn bearings in the link-arms

Post Reply
VikingHighlander
Posts: 8
Joined: Thu Nov 14, 2019 4:05 am

G2 pro - warn bearings in the link-arms

Post by VikingHighlander » Tue Nov 19, 2019 7:21 pm

Where can I get new bearings or complete arms for my Delta G2 pro?
Can I change only the ends with the bearings (with the screw/bolt into the axis-mounts and extruder-mount)? :roll:

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: G2 pro - warn bearings in the link-arms

Post by William » Wed Nov 20, 2019 9:29 am

Hi, you can provide a specific picture.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

VikingHighlander
Posts: 8
Joined: Thu Nov 14, 2019 4:05 am

Re: G2 pro - warn bearings in the link-arms

Post by VikingHighlander » Thu Nov 21, 2019 5:36 pm

Arm_bearings.JPG
Arm_bearings.JPG (94.04 KiB) Viewed 18046 times
the ball-bearings at the ends of the arms holding the extruder & fan (which moves around when printing).
These seem to be worn. There is a little slack when I wiggle them.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: G2 pro - warn bearings in the link-arms

Post by William » Thu Nov 21, 2019 5:46 pm

Hi, you refer to the: diagonal rod.
`2PQ`}H[W@{Z4%Q3~VRP5_5.png
`2PQ`}H[W@{Z4%Q3~VRP5_5.png (19.26 KiB) Viewed 18045 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

VikingHighlander
Posts: 8
Joined: Thu Nov 14, 2019 4:05 am

Re: G2 pro - warn bearings in the link-arms

Post by VikingHighlander » Thu Nov 21, 2019 7:41 pm

yes. Can I buy new ones?

VikingHighlander
Posts: 8
Joined: Thu Nov 14, 2019 4:05 am

Re: G2 pro - warn bearings in the link-arms

Post by VikingHighlander » Thu Nov 21, 2019 8:31 pm

Found another problem too.
the bearings in the pulley at the top of the y-axis belt was warn out too. see pic below.
I dont have the instructions/parts catalogue. The link to it on the forum was also dead.

can I have the pars number for this bearing aslo + a link to the instructions?

Do you sell the diagonal rods + pulley bearings?
bearings pulley belt.JPG
bearings pulley belt.JPG (114.24 KiB) Viewed 18043 times

Post Reply