Hello,
I'm looking for profiles for the A20M to be used with Repetier Host and the Slic3r software.
The print of the test Dog is quite well but my own parts I tested were underextruded. So I increased extrudion to 120% and later to 150%, but it didn't help.
Or should I try a slower speed?
Is there a Config Bundle available for Slic3r?
Moritz
Profiles for Repetier Host / Slic3r for A20M?
Re: Profiles for Repetier Host / Slic3r for A20M?
Maybe mine's is not perfect.
But you can have a try:
But you can have a try:
Re: Profiles for Repetier Host / Slic3r for A20M?
Does the extruder working temperature achieve Preset temperature?
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Profiles for Repetier Host / Slic3r for A20M?
Hello William,
I don't have a thermometer, therefore, I didn't check this. The Dog was printed with 205°C:
This looks very good, I think.
See Discussion here: http://www.geeetech.com/forum/viewtopic ... 08&t=68468
Thanks,
Moritz
Re: Profiles for Repetier Host / Slic3r for A20M?
Hi,BR365
I am using the PETG for my A20M.
You can change the temp of the bed+temp of the hotend.
Then the others settings same as my PLA setting
I am using the PETG for my A20M.
You can change the temp of the bed+temp of the hotend.
Then the others settings same as my PLA setting
Re: Profiles for Repetier Host / Slic3r for A20M?
If you want to calibrate your estep.
Refer to this vid:
https://www.youtube.com/watch?v=X3A9Ir2SreI
My estep is 457
Refer to this vid:
https://www.youtube.com/watch?v=X3A9Ir2SreI
My estep is 457
Re: Profiles for Repetier Host / Slic3r for A20M?
Thanks, I will check.Tomyuan wrote: ↑Thu Apr 25, 2019 1:57 pmIf you want to calibrate your estep.
Refer to this vid:
https://www.youtube.com/watch?v=X3A9Ir2SreI
My estep is 457
My current value is 340, AFAIK.
Re: Profiles for Repetier Host / Slic3r for A20M?
Hi Vert,
I guess, the only possible solution is to remove these disks.
E-Steps changed to 422 (Calibration done), ...
No new result depending the stringing.
I guess, the only possible solution is to remove these disks.
E-Steps changed to 422 (Calibration done), ...
No new result depending the stringing.