Not moving on X or Y axis

Post Reply
Jon30b
Posts: 23
Joined: Thu Aug 15, 2019 3:13 am

Not moving on X or Y axis

Post by Jon30b » Sun Apr 18, 2021 8:12 pm

The extruder wont' move on the X or Y axis. I have updated the firmware and I know the X axis rods are level because I have adusted them using a spirit level?

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Not moving on X or Y axis

Post by Admin » Tue Apr 20, 2021 5:55 pm

Hello, you can check whether the limit switch can work normally, it may be that the limit switch is stuck, please reconnect it.
In addition, you can also directly exchange the x-axis and Z-axis motor connection lines on the main board. This method can be used to test whether the motor problem is the main board or the drive problem.

Post Reply