Irregular temperature increase

Post Reply
rezjat
Posts: 1
Joined: Thu Oct 08, 2020 1:04 am

Irregular temperature increase

Post by rezjat » Thu Oct 08, 2020 1:15 am

Hi.

Since some weeks ago, I observe that when starting temperature increase towards its target, from around 150º it start to show a quite irregular curve (up and down values), instead of a smooth curve as It was before.
But once it gets the target (in a very irregular way), it works normally...

Any suggestions? Is it a signal of thermistor starting failing? I disconnected connectors at main board and connected again but no differente...

Thanks a lot!

Javier

User avatar
William
Site Admin
Posts: 6338
Joined: Tue Jun 07, 2016 9:38 am

Re: Irregular temperature increase

Post by William » Sat Oct 10, 2020 2:57 pm

Hello, it may be that the thermistor is not too sensitive, but if it can be used normally, don't worry. :D
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply