Page 1 of 2

Not printing

Posted: Sat Aug 17, 2019 9:54 pm
by Jon30b
When I load in a gcode file into EasyPrint 30 and set the COM port and the printer to I3ProB I click Run Job and nothing happens. The printer has the CH340 chip and I have installed the drivers for it.

Re: Not printing

Posted: Mon Aug 19, 2019 9:29 am
by William
Hi, Can you provide a specific video?

Re: Not printing

Posted: Tue Aug 20, 2019 9:23 pm
by Jon30b

Re: Not printing

Posted: Wed Aug 21, 2019 9:17 am
by William
Hi, You need to connect the printer and then slice the model.
设置.png
设置.png (145.85 KiB) Viewed 503 times

Re: Not printing

Posted: Wed Aug 21, 2019 8:01 pm
by Jon30b
I connected, clicked slicer, then when it was done I clicked Run Job and still nothing happened.

Re: Not printing

Posted: Thu Aug 22, 2019 9:00 am
by William
Hi, Have you chosen the correct port to connect?
Can you provide your specific slice video?

Re: Not printing

Posted: Fri Aug 23, 2019 3:16 am
by Jon30b
I am connecting to COM 3 which matches with the driver installed:

https://drive.google.com/file/d/12-lg-i ... sp=sharing

Video: https://www.youtube.com/watch?v=UOg-EDFN14Q

Re: Not printing

Posted: Fri Aug 23, 2019 9:24 am
by William
Hi, You need to connect the printer before slicing.
After connecting, you can see the hot end
and hotbed temperature status of the printer at the bottom.

Re: Not printing

Posted: Sat Aug 24, 2019 3:37 am
by Jon30b
I have tried this and still nothing is printing. The extruder is staying on 25.9°C and the off bed is staying on 49.6/50°C.

Re: Not printing

Posted: Mon Aug 26, 2019 10:49 am
by William
Hi,Are you setting up the printer?
Set the print temperature in the extruder and hot bed in the consumables?