config.ini

[colin.eamens@c-eamens.wales]

I have finaly finishing building my Rostock 301 3D Printer and am in the process of setting it to start my first print. following the Manual i have levelled the Hot bed and am now on the set up the slicer softeare.

It mentions loading a Rostock 301 PLA config .ini file.

Where do i find this also will i need to load a ABS config.ini file as well

I am going to try with ABS first

[William]

ABS is sensitive to temperature, so I do not recommend that you start your journey with ABS printing

[colin.eamens@c-eamens.wales]

Thank you, I have also bought some PLA so will take your advice and try thhat first.

Do you know where to find the Config file mentioned in the user manual.

Thanks

[William]

It is my own Rostock 301

Rostock301.zip

(1.59 KiB) Downloaded 643 times

config.ini

[William]

I think you can use Repetier-Host for slicing