Page 1 of 1
Filament not feeding
Posted: Sun Jan 17, 2021 5:18 am
I just got my A30 printer and the filament for my #0 stops feeding or doesnt feed at all constantly. I can see that the wheel is turning to push it through but it feels stuck. If start pushing it super hard it goes again. I tried adjusting the tension with the screw on the side but it doesnt seem to change anything.
Any ideas? This is really frustrating as it makes the printer useless.
Nozzle temp is right at 200C
Filament is geeetech brand PLA
Re: Filament not feeding
Posted: Thu Jan 28, 2021 4:52 pm
Hello, you can use the search function in the forum to find a solution easily.
If it is a hardware problem, you need to contact geeetech official, please use the ticket system to communicate with them.