Install 3D touch instead of capacitive proximity senso

Post Reply
Ton
Posts: 1
Joined: Tue May 26, 2020 12:03 am

Install 3D touch instead of capacitive proximity senso

Post by Ton » Fri Sep 04, 2020 5:43 pm

Hi,

I've been searching the forum to use 3D touch on A30 that has pre installed sensor slot for capacitive sensor but i want to use 3D touch.
Already installed 1.37.58 version of firmware. Also removed the male pins intended for the capacitive sensor and connected the 5 pins accordingly for the 3D touch instead. Take note that i did not use the 3 pin slot. I used the 5 pin slot.

Enabled the 3D touch mode and the auto leveling to let me test the installed 3D touch. But it doesn't work. Please can anyone help me.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Install 3D touch instead of capacitive proximity senso

Post by William » Mon Sep 07, 2020 4:42 pm

Hello, you can check if there is an adapter board interface on your hot end, just connect 3d to the adapter board. :D
Attachments
a30zhuanjie.jpg
a30zhuanjie.jpg (45.86 KiB) Viewed 4770 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply